Honeywell 5853: How to Change the Battery in the Device?

This how-to-video will show you how to replace the battery in the Honeywell 5853 wireless glass break detector.

To change the battery on the Honeywell 5853 wireless glass break detector open the sensor by prying the top open allowing for the front plate to fall down. Go ahead and pull the old battery out, grab your new matching battery and slide the new battery into place. Look for the two lights on the bottom to flash and than seal the front plate back in place and you are all set you can expect another 3-5 years of service from this battery depending on how often it is in use. This Honeywell 5853 wireless glass break detector uses a CR123A 3V battery.

If you are looking for a second barrier of defense in your home or business the Honeywell 5853 glass break detectors are wonderful. The Honeywell 5853 glass break detector will pick up all UL listed glass break frequency's. So unlike door or window contacts that work great if the intruder decides to pry open a door or window the Honeywell 5853 glass break detector defend's against and intruder shattering a door or window and entering without separating the contact from the magnet.


For the lowest No-Term alarm monitoring rates contact GEOARM Security. 

View all of our DIY Security Frequently Asked Questions

Contact: http://www.geoarm.com/contact.html

Product: http://www.geoarm.com/honeywell-wireless-glassbreak-detector-5853.html

Battery: http://www.geoarm.com/123-lithium-battery-cr123-dl123a-el123ap-el123apbp.html

Alarm Monitoring : http://www.geoarm.com/alarm-monitoring-services.html

Did you find this article helpful?